1) change the routers gateway IP address from 192.168.254 to 192.168.1.1 . 2) disable DHCP. 3) connect the two routers together via ports eth 1, don't use eth 4 if the technicolor is a version intended for vdsl. If you're still having problems test the power line adapters are working by connecting a laptop in place of the technicolor router. HTH 2. Connect the printer to the USB port on your router. If your router has a USB port, you can easily connect your printer to the router using the USB port. [1] 3. Power on the printer and wait 60 seconds. If you haven't already done so, plug the printer into an electrical outlet or power strip. More Information - Technicolor DGA0122. Featuring the Wi-Fi 5 standard (IEEE 802.11ac) for the 5 GHz band, this dual band Wi-Fi solution makes optimal use of the radio spectrum. With its optimised antenna configuration, the DGA0122 enables even higher throughput and better coverage over the much less crowded 5 GHz radio. Router Quick Start Guide Technicolor DGA0122 & DWA0120 Switch router on. Status light will be orange, Broadband light should blink then go steady Plug in the supplied power cable Connect your computers or your network to ports 1-4. Connect DSL port to the phone socket via a splitter (optional) using the supplied 'grey' cable. The router will be Destination IP: Select or enter the internal IP address of the device to forward the port to. Press the Plus (+) icon to the right to save and apply that port forward rule. Repeat steps 3-5 for any additional ports you wish to add. Press "Close" once you are happy with your changes. It is recommended that you turn off the gateway first, then disconnect or unplug any existing Ethernet cable plugged into the gateway’s local-area (LAN) port. Plug it into your new router’s WAN port and switch the gateway back on. Wait a moment for it to boot up, before plugging in the router’s power supply. Login to your Technicolor TG784n router. Make your way to the port forwarding section of the router. Click the Toolbox link. Click on Game & Application Sharing. Click the Create a new game or application link. Enter a name in the Name box. Click the Manual Entry of Port Maps radio button. Click the Next button. We will send you an email to confirm which of the numbered ports you should connect your router to. Plug in all relevant cables and NBN devices (if applicable). You can find a plug labelled WAN on your modem or router. Click your connection type below to see a diagram of what cables you need to connect. Fibre to the Premises (FTTP) Fixed The strangest thing is though, If I go to the other router which is connected to the technicolor router via an ethernet cable, and has DHCP, UPNP etc turned off and a static IP within the same range (192.168.1.252) (which is purely used as a wireless access point, and has been working like this for months), this too cannot see the internet via hJaVZ.

how to connect technicolor router